Máy mài : PWSA 5/130 HV

Catalogue section 2:

TC burrs
Cut 3, 3 PLUS, 4, 5, STEEL, INOX, NON-FERROUS, CAST, TOUGH, TOUGH-S, MICRO, ALLROUND, TITANIUM
Dia. 10 to 16 mm
HSS rotary cutters
Cut 1, 2, 3, 5, special cuts
Dia. 2.3 to 7 mm

Catalogue section 3*:

Mounted points
Shank diameter of 6 mm:
Dia. up to 16 mm
Dia. 16 to 32 mm
Width ≤ 40 mm
Dia. 40 to 50 mm
Width ≤ 25 mm
Shank diameter of 8 mm:
Dia. 32 to 50 mm
Width ≤ 50 mm

Catalogue section 4*:

Poliflex fine grinding discs
Bond:
TX
Dia. 25 to 40 mm
POLICAP
Dia. up to 13 mm
COMBIDISC abrasive discs
Dia. 20 to 50 mm
COMBIDISC TX discs
Dia. 50 and 75 mm

Catalogue section 5:

Diamond grinding points
Dia. 12.0 to 20.0 mm
Diamond cut-off wheels
Dia. 22 and 50 mm
matching
ArborsBO 3/1,7 1BO 6/10 3BO 8/10 3
or
adapter setSAS 10/50

Catalogue section 6:

Cut-off wheels EHT
Dia. up to 50 mm
matching
ArborsBO 6/6 0-4BO SPG 6/6 0-10
Ring wheels ER
Dia. up to 50 mm
matching
ArborsBO 6/6 3-10BO 8/10 6-20BO SPG 6/6 0-10BO SPG 6/10 0-10

Catalogue section 8:

Shank mounted end brushes
crimpedPBU dia. 10 to 20 mm
crimped with ring
PBUR dia. 13 mm
knotted
PBG dia. 19 to 23 mm
Shank mounted wheel brushes
crimpedRBU dia. 20 to 30 mm
If no shank diameter is given, the shank dia. of 6 mm applies.
*Catalogue sections 3/4: This data applies to an unsupported shank length of 10 mm and the max. stated mounted point dimensions.Note: Please observe the recommended cutting speeds and the max. permitted rotational speeds in catalogue sections 2-8.